5.4 Machine Stopping
When you need to stop the Automatic Injection Blow Molding Machine, select the screw mould up quickly to depart from the blow mould, after the unrod air cylinder takes out the bottles and returns back, pressing the manual button, and then the semiautomatic or automatic running will be stopped. Finally, switch off the oil pump motor, electrothermal switch and the main power supply in sequence.
The valve for entering water should also be shut off after the Automatic Injection Blow Molding Machine being stopped, meanwhile, all the water in the waterway should be drained out, and the air source should be stopped too.
If emergency happens, press the emergency stop button on the electric control panel at any moment.
|
